Eye Lags For Sammy Drivers & Poles

Sammy Screws designed for concrete applications.  Easy, fast install.  Just drill a quarter inch hole and drive in.  Available in 1/4" and 3/8" sizes. Also available in a horizontal mount version.  Use Sammy driver 14.

Sammy Screws designed for concrete applications.  Easy, fast install.  Just drill a quarter inch hole and drive in.  Available in 1/4" and 3/8" sizes. Also available in a horizontal mount version.  Use Sammy driver 14.

DST Sammy Screws For Steel.  These self drilling anchors are a great time saver.  You will find them with a tek 3 point for thin gauge steel and a tek 5 for thicker steel.  Available in 1/4" and 3/8" sizes.

SWD Sammy Screws For Horizontal Steel Applications.  These self drilling anchors are a great time saver.  You will find them with a tek 3 point for thin gauge steel and a tek 5 for thicker steel.  Available in 1/4" and 3/8" sizes.

Sammy Screws all thread anchor designed for wood applications.  Easy, fast install with no pre drilling required.  Available in 1/4" and 3/8" sizes.  Also available for horizontal applications.

SWGST Sammy Screws all thread anchor designed for horizontal wood applications.  Easy, fast install with no pre drilling required.  Available in 1/4" and 3/8" sizes.  Also available for vertical applications.

The Sammy X-Press® System is designed to provide direct attachment of threaded rod in metal deck (22-16 gauge), while providing reduced installation costs in terms of time and materials. (Check out the video) The X-Press System features an easy-to-install anchor with expanding anchoring strips that collapse to prevent pullout after installation. The Sammy X-Press-It® Installation Tool assures a perfect installation every time, offering the added convenience of one-tool efficiency – just drill and drive in seconds!  UL listings and FM approvals are available. Available for ¼”,  & ⅜”added convenience of one-tool efficiency – just drill and drive in seconds!  UL listings and FM approvals are available. Available for ¼”,  & ⅜”

Sammy X-Press Sidewinder® provides a side mount solution when attaching threaded rod in metal deck (minimum 22 gauge) and purlin (minimum 16 gauge). This labor and cost savings overhead attachment allows for easy adjustment, eliminating the need to cut threaded rod on-site. Available for ⅜” threaded rod.  UL listed for pipe hanger and end-of-line restraint .

Our Sammy Swivel® technology eliminates distortion of threaded rod and allows rod to hang plumb in pitched applications. Products offer an angled 89° in z-purlin and 45° in metal deck for a 12/12 pitch. The Swivel X-Press™installs in seconds while saving time & installation costs. Use this product in applications where access to the back of the installed fastener is prohibited. No retaining nut required. UL Listed for pipe hanging and end-of-line restraint.  Available for ⅜” and ½” threaded rod.

The Sammys Toggle has the functionality of a standard wing toggle and provides threaded rod anchoring ability. This three-piece wing toggle anchor is used vertically in pre-cast hollow core concrete, drywall applications, hollow tile, metal lath, and plaster. This product is available for ¼” and ⅜” threaded rod.

Drivers, kits and accessories to properly install Sammy Super Screws.  We even have a pole to install Sammy Screws to the ceiling from the floor with the rod already attached!