 |
Tie Wire Wedge Anchor Box of 100. Tie wire wedge anchors for suspending ceiling grid wire and jack chain. Easy to install, drill 1/4" hole, hammer in and pull down. A great option when concrete is to brittle to shoot or you are looking for a little more holding power than a powder actuated clip will offer. Available pre tied to ceiling grid wire and now can be easily installed from the floor with the ODM Overhead Drill Machine and I Driver. Maximum static load should not exceed 100 lbs. Test data.
Compare to:
Hilti's Ceiling Anchor HHDCA 1/4"®
Red Head's 1/4" x 2-1/8" Tie Wire Wedge Anchor®
UCAN's Tie Wire Anchor®
Powers' Tie Wire SPIKE Anchor®
- STI Independent Testing
- Silver zinc plated
- Overall length is about 2-1/4″
- Eyelet size about 9/32″
- Length from collar to point is about 1-1/4″
- Diameter: 1/4″
- Hole is designed to accommodate 12-gauge ceiling wire, ¼” bolt or smooth rod
- May be installed from the ground using an ODM-G2™ pole tool, ODM-250 SDS bit & I-WEDGE™ Installation tool
- May be pre-tied to ceiling wire
|
|
|